Birthday Card Khud Banayen

[saraah]

Supplies Needed for this card:

-

Instructions: (Use picture as placement example)

1. Using decorative edged scissors, cut out a 5.5 cm wide strip of light pink scrapbook paper that is the width of your card.
2. Adhere this strip now on a piece of medium pink scrapbook paper. Cut a thin border on each long side out. Adhere this strip now on the bottom of the card about 1 cm from the edge.
3. Die cut 3 butterflies out of the medium pink paper. Cut a strip of paper out that is the width of your card and around 1 cm wide. Insert this strip through the butterflies and adhere 3-D foam tape on the backside to secure the butterflies to the strip. Now adhere the butterfly strip on the card as seen in the picture.
4. Cut out a strip of medium pink paper that measures 2 x 10 cm. Color the peel-off wish and adhere this to the strip. Lay the strip on the top center of the card and now punch a hole through each corner and at the same time through the front cover of the card. You may need to place something soft under the card to make the punching easier. Insert the brads to secure this strip to the card.

[saraah]

Re: Birthday Card Khud Banayen


1. This is the Sidekick from Sizzix.

2. These are just a few of the many templates you can purchase for the Sidekick. You can find templates for all seasons, tag tamplates, shapes and words.

3. These are the cutting plates. They are provided when you purchase the Sidekick.

4. The first step is to cut pieces of cardstock or paper to the size of about 6 x 6 cm (about 2.4 x 2.4 inches). This size fits perfectly within the Sizzix Sidekick.

5. Lay your first acrylic cutting plate on the table. Then you will lay the template over it with the soft side up as you see here.

6. Now you will take your cut piece of paper or cardstock and lay it over the template.

7. Take the second acrylic cutting plate and lay it over the cardstock sandwiching everthing within.

8. Pull the left side lever to the other direction until the Sizzix Sidekick is firmly attached to the table. If it does not get a grip to the table, try again by pulling the lever again to the front and then to the back. It is important that the Sidekick grips securly.

9. Insert your prepared layers into the opening in the center of the Sizzix Sidekick.

10. Start turning the knob on the left side towards you and the Sidekick will pull the layers into it.

11. Keep turning the knob until the layers are completely through to the backside.

12. Remove the cutting plates and the template and this is how your cardstock now looks.

13. Punch out the cut motifs and they are ready to use for your next project

[minal]

Re: Birthday Card Khud Banayen

Saraah Can U Tell Me How 2 Make Italian Dough

[saraah]

Re: Birthday Card Khud Banayen

Saraah Can U Tell Me How 2 Make Italian Dough

SURE.....JUST WAIT A BIT...........:rose